specific SAFETY RULES
Use
Replace any blade or other parts that are cracked or damaged. Always make sure blade is installed correctly and securely fastened before each use. Failure to do so can cause serious personal injury to the operator, bystanders, or damage to the unit.
Never cut any material over 3/8 in. diameter.
Maintain a firm grip on handle while cutting with a blade. Keep the blade away from body.
Know how to stop the unit quickly in an emergency.
Check damaged parts. Before further use of the shrubber, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other condition that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless indicated elsewhere in this manual.
Install the padlock (not included) or
Service on the product must be performed by qualified repair personnel only. Service or maintenance performed by unqualified personnel could result in injury to the user or damage to the product.
Always stop motor and install padlock (not included) or
Battery powered units do not have to be plugged into an outlet; therefore, they are always in operating condition. Be aware of possible hazards even when the unit is not operating.
NEVER attempt to change the cutting attachments without first padlocking (not included) the switch or installing the
Never use shrubber if the switch will not turn the unit on or off. A unit that cannot be controlled by the switch is dangerous and must be repaired before use.
Shrubber is for cutting hedges and shrubbery only. Do not use for any other purpose.
Maintain shrubber with care. Keep cutting edge sharp and clean for best performance and to reduce the risk of injury. Follow instructions for lubricating and changing accessories. Keep handles dry, clean, and free from oil and grease.
Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operating condition. Be aware of possible hazards when not using your battery tool or when changing accessories. Following this rule will reduce the risk of electric shock, fire, or serious personal injury.
Do not place battery tools or their batteries near fire or heat. This will reduce the risk of explosion and possibly injury.
Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has been dropped or received a sharp blow. A damaged battery is subject to explosion. Properly dispose of a dropped or damaged battery immediately.
Batteries vent hydrogen gas and can explode in the presence of a source of ignition, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless product in the presence of open flame. An exploded battery can propel debris and chemicals. If exposed, flush with water immediately.
For best results, your battery tool should be charged in a location where the temperature is more than 50°F but less than 100°F. To reduce the risk of serious personal injury, do not store outside or in vehicles.
Save these instructions. Refer to them frequently and use them to instruct others who may use this tool. If you loan someone this tool, loan them these instructions also to prevent misuse of the product and possible injury.
Page 5 — English
