ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury.
nInspect the product carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the product.
nIf any parts are damaged or missing, please call
PACKING LIST
Electric Pressure Washer with Hose and Reel Assembly and
Handle Assembly Spray Wand
Spray Wand Storage Bracket Bolts (2) (M6 x 40)
Washers (4) Nuts (2)
Hose Reel Handle
Screw (M4 x 12) Wheels (2) Axles (2)
Hitch Pins (2) 15º Nozzle Turbo Nozzle
TOOLS NEEDED
4 mm Hex Key Screwdriver Adjustable wrench
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is com- plete. Failure to comply could result in accidental starting and possible serious personal injury.
INSTALLING THE WHEELS
See Figure 4.
n Locate the axles, hitch pins, washers, and wheels.
n Slide the axle through the hole in the center of the wheel.
n Slide a washer onto the axle before inserting into the frame.
n Lift the machine and slide the axle into the wheel mount- ing hole in the machine base as shown.
n Slide the washer on the axle, then push the hitch pin into the hole on the end of the axle to secure the wheel assembly.
NOTE: The hitch pin should be pushed into the axle until the center of the pin rests on top of the axle.
n Repeat with the second wheel.
ATTACHING THE HANDLE ASSEMBLY
See Figure 5.
n Orient the handle assembly as shown.
nDepress the button on the handle assembly and insert into the holes on the pressure washer. Press down on the handle assembly until the button on the handle clicks into place.
nLower both collars on the handle and rotate clockwise until secure.
ATTACHING THE SPRAY WAND STORAGE BRACKET
See Figure 6.
n Place the spray wand storage bracket over the holes in the frame.
nInsert a bolt through each of the holes.
nSlide a washer and a nut over each bolt and securely tighten.
