4. INSTALLATION
It is your responsibility to choose
a boat suitable for the engine (5
horsepower).
manufacturer’s power recommen-
dation. Damage and injury may
result.
1. Installation Position
Install at the stern at the center line
of the boat.
2. Installation Height
Make sure that the transom height
is correct for the motor. Incorrect
installation height will reduce per-
formance.
The motor should be installed so
that the anti-cavitation plate is
2-5 cm (0.8-2.0 in) below the
bottom of the boat.
CAUTION: The water level must
be at least 4 inches above the anti-
cavitation plate, otherwise the
water pump may not receive suffi-
cient cooling water, and the exten-
sion case will overheat.
3. Motor Attachment
Attach the stern bracket to the
transom and tighten the clamp
, screws.
CAUTION:
0 While operating the boat, check
the tightness of the clamp
screws occasionally.
0 Tie a rope through the hole in the
stern bracket and secure the
other end of the rope to the
boat. This will prevent acciden-
tal loss of the motor.
TRANSOMrHElGHT
5ss+f+
fi STERN CENTER
2-5 cm
-.
t
(0.8-2.0
SAFETY\ ROPE