Honda Power Equipment manual GA-2.5H Controls and Indicators, Generator Components

GA-2.5H — CONTROLS AND INDICATORS

Figure 2A. Generator Components

1. 120V Output Receptacle – This NEMA L5- 20R twist- lock receptacle will provide 120V, 20 amps, 60 Hz. Applies to units with S/N 5496763 and above.

2. GFCI Receptacle – This 5-20R duplex receptacle will provide 120V at all times.

3. AC-Voltmeter – This voltmeter indicates (with a mark) the rated 60 Hz, single phase output voltage. In addition the voltmeter can also be used as a diagnostic tool. If the voltmeter indicator (needle) is below the rated voltage, engine problems may exist (low/high RPM's). To prevent damage to the generator or power tools turn the generator OFF and consult your authorized MQ service dealer.

4. Ciruit Breaker – To protect the generator from an overload, a 2- pole 20 amp circuit breaker is provided on the control box. Make sure to place the circuit breaker to the "OFF" postion prior to starting the engine.

6. ON-OFF Switch – place engine ON/OFF switch in the "ON" position for normal operation. To turn- off the generator place switch in the "OFF" position.

7. Chassis Ground – This ground connection point should be connect to a good earth ground (ground rod). Applies to units with S/N 5496763 and above.

This HONDA engine is equipped with a low oil shutdown capability. A built in sensor will

NOTEautomatically turn off the engine should the oil level fall below a safe operating condition. Make sure the generator is placed on

level ground. Placing the generator on level ground will ensure that the low oil sensor will function properly.

5. GFCI Ground – This ground connection point should be connect to a good earth ground (ground rod). Applies

to units with S/N 5496762 and below.

PAGE 16 — GA-2.5H A.C. GENERATOR — OPERATION & PARTS MANUAL — REV. #4 (10/07/05)