![](/images/new-backgrounds/1113618/11361847x1.webp)
GA-2.5H — INITIAL START-UP ENGINE/OPERATION
6.If the engine has started, slowly return the choke lever (Figure 11 ) to the “OPEN” position. If the engine has not started repeat steps 1 through 5.
7.Before the generator is placed into operation, run the engine for
8.Refer to the AC voltmeter (Figure 14) on the control panel.The voltage indicated on the voltmeter should be 120 VAC with no load applied.
Stopping The Engine
Normal Shutdown
1.Place the main circuit breaker (Figure 9) in the OFF position.
2.Remove the load from the generator, and let the engine run at idle for
3.Place the engine ON/OFF switch (Figure 17) in the "OFF" position.
Figure 17. Engine ON/OFF Switch (OFF)
Figure 14. AC Voltmeter (120 VAC)
9.If desired, verify with a voltmeter (Figure15) that 120 VAC is present at the GFCI duplex receptacle and the 120V
Figure 15. 120 VAC GFCI Receptacle Connecting the Load
1.Connect the load to the output receptacles.
2.Place the main circuit breaker (Figure 16) in the ON position.
4.Place the engine fuel valve lever (Figure 18) to the "OFF" position.”
Figure 18. Engine Fuel Valve Lever (OFF Position)
Emergency Showdown
1.Place the engine ON/OFF swith (Figure 17) in the "OFF" position.
Figure 16. Main Circuit Breaker (ON)
PAGE 24 —