VIBRATOR HEADS AND SHAFTS MAINTENANCE
HEADS
| A2231 | A2232 | A2233 | A2234 | A2235 | A2236 |
| |
Fig. No. | 3/4" Dia | 1" Dia | 1 3/8" Dia | 1 3/4" Dia | 2" Dia | 2 3/8" Dia | Complete Head | |
Assy. | ||||||||
|
|
|
|
|
|
| ||
44 | Housing | |||||||
45 | Lock nut, Bearing | |||||||
46 | Bearing (4) | |||||||
47 | Weight, Eccentric | |||||||
48 | Core Adapter | |||||||
49 |
|
|
|
|
| Housing Bearing | ||
50 |
|
| Seal (2) | |||||
50a |
|
|
|
| Seal (Oil) | |||
50b |
|
|
|
| Seal (Grease) | |||
51 | Casing Adapter |
ASSEMBLY
CAUTION: Turn off the motor before performing any maintenance or fitting any components to the motor.
ASSEMBLING SHAFT TO MOTOR
1.The end of casing with the strain relief spring goes into the motor casing adapter.
2.Insert inner core of the shaft into the core adapter on motor. Make sure the core is fully inserted.
3.Coat threads on casing coupler with Permatex
4.Thread casing coupler counterclockwise into adapter on power unit and tighten securely using open end wrenches on the flats. NOTE: These are
TIGHTEN
LOOSEN
ASSEMBLING VIBRATOR HEAD TO SHAFT.
1.Coat threads on casing coupler with Permatex
2.Push core toward motor end to make certain it is still engaged in the motor. Insert exposed end of core into head core adapter.
3.Holding casing coupler with an open end wrench on the flats, thread the head on counterclockwise and securely tighten with a pipe wrench.
CAUTION: Put pipe wrench only on the very end of the head to which the flexible shaft is being attached.
FLEXIBLE SHAFTS
- 27 -
