Honda Power Equipment MM52 manual Adjusting Cutting Height, mBe sure all moving parts have

ADJUSTING CUTTING HEIGHT

1.Park the tractor on a level surface and set the parking brake.

2.Make sure the Main Transmission Lever is in “NEUTRAL”and the PTO levers are “OFF” and the lift lever is in the center (NEUTRAL) position.

3.Start the engine, move the hydraulic cylinder selector lever (if installed) to “FRONT” and raise the mower deck fully with the Lift Selector lever.

4.Turn the Lowering Speed Adjust knob fully clockwise to lock the hydraulic system.

5.Set the Lift Selector lever to “DOWN” to be sure the mower deck is locked in the fully raised position. Deck should not descend. Return the lift lever to “NEUTRAL”and then stop the engine and remove the ignition key.

t A-

mBe sure all moving parts have

stopped before adjusting cutting height. Contacting moving parts can cause injury.

6. Remove the locking ,pin from the gauge wheel and set the wheel for the desired cutting height.

7. Repeat the adjustment procedure for the other gauge wheel.

NOTE: Both gauge wheels must be set to the same height.

8.If necessary, remove the nut and bolt from left, right and center anti-scalping rollers, and set the anti-scalp rollers for the desired cutting height. This height is determined by which hole is used in anti-scalping wheel brackets. As illustrated, top hole sets height of 1.5 in, middle hole 2 in and bottom hole 2 l/2 in. Make sure to set all anti-scalping rollers to same height.

9.Insert the bolt into the anti-scalp roller bracket and secure it with the nut.

30