Honda Power Equipment MM52 manual Installing Mower, Installing Lift Link

INSTALLING MOWER

INSTALLING LIFT LINK

mWear heavy gloves to protect ybur’haids when installing lift link kit and mower deck.

1, Grease the lift arm shaft thourghiy, then insert through the pivot bosses on the main frame from the left side.

2.Slide the right lift arm onto the end of the lift arm shaft, Install the lift arm pin through the lift arm shaft and secure with lock pin.

3.Assemble the deck lift rod using turnbuckle shaft with two threaded ends and indentation in middle, two ,625 in. nuts and two .625 in. clevis.

NOTE: One end of turnbuckle shaft, one clevis and one locking nut are LEFT HAND THREAD. Note the dashed marks on the left hand thread clevis to identify. Do not cross-thread. Screw on both ends of cievis to same depth, so that in adjusting, one end does not come loose.

Adjust the length of the deck lift rod to 379-382

mm(149-l 5.0 in) measured eye to eye.

4.Lubricate the lift arm pin with grease, then insert the threaded end of the lift arm pin through the front link arm and install the lock nut on the end of the pivot. Tighten the lock nut securely.

5.Slide the lift link assembly with flat washer onto the link shaft projecting from the frame. Simultaneously, slide the hole in the front part of the lift link assembly over the lift arm pin. Attach link assembly to link shaft with plain washer and lock pin. Attach front of lift link assembly with plain washer and cotter pin.

6.install the deck lift rod between the left lift arm and the front link (passing below front axle) using two anti-rotation pins installed from inside.

Et;:: with two linchpins installed from top to

.