Graco 312394V important safety instructions Installation, Polyethylene Tank Lid with Agitator

Installation

Polyethylene Tank Lid with Agitator

Installation

7. Attach appropriate hoses and cables.

The polyethylene tank lid o-ring is installed with Kry- tox. Contact with Krytox can lead to flu-like symp- toms. The MSDS for this material is available upon request.

•For electric agitator models, plug the agitator power cable into one of the outlets in the incom- ing power bracket then turn on the power switch located on the agitator.

	Power Outlets
213	to Electric Agi-
	tator

222

224 ti12583a

214 ti12558a

1.Remove tethered quick-release pin (213) from both sides of tank support beam (224).

2.Slide the clamp (222) out of each side of the sup- port beam (224) until it hits the stop.

3.Rotate the clamp (222) 180 degrees about the shoulder screw (214) so it is hanging freely.

4.The tank lid assembly can now be removed or installed as required. Install tank lid assembly onto tank body.

5.Rotate the clamp (222) 180 degrees about the shoulder screw (214) so it is in position to secure the tank lids.

6.With the clamps in position, slide the tethered quick-release pin (213) into place.

312394V 13