
Vacuum De-gas and Vacuum Auto-Fill
This procedure is for assemblies with a Vacuum Tree Manifold, Agitator, and
1.Press the Select Operating Mode button ( ) repeatedly to select Shot, Sequence, or Operator (Manual) mode.
2.Close the
3.If the tank lid requires a desiccant dryer or nitrogen pump installed, install one into the top ball valve of the vacuum tree manifold (1015).
4.Close the top ball valve of the vacuum tree manifold (1015).
5.Attach vacuum pump to the bottom ball valve of the vacuum tree manifold (1015) then open the ball valve.
6.Turn on the vacuum pump.
7.Turn on agitator.
8.Select Manual
9.Press the Initiate ). The
Active Shot/Sequence button ( ) and Select
Operating Mode button ( ) will each change to
the or
) if a valid
10.Press the appropriate
or buttons ( and/or
) to select the tanks to refill.
11.Press the Initiate ) or the
Enter button ( ) to confirm.
Setup
12.If necessary, press the Abort/Cancel button () to cancel
If an will not initiate a new
CAUTION
If an
13.Continue to
14.Close bottom ball valve of the vacuum tree manifold (1015).
15.Turn off the vacuum pump.
16.Open the top ball valve of the vacuum tree manifold (1015).
CAUTION
Operating the tank after the vacuum
17. Open the shutoff valves at the base of the tanks.
312394V | 21 |