ASSEMBLY
1.Secure the landside to the frog with two . %If x 1" plow bolts and square nuts; finger tighten. Next, mount the brace between the moldboard and the landside with %It x 1If plow bolts and square nuts. Tighten all bolts securely.
2.Assemble the standard to the landside assembly after inserting the land adjusting bolt (94"x 2%" hex) through the tabon the standard and into the square nut. Then install the carriage bolt and square nut at the top hole, and the 'Affx 2" plow bolt and square nut (not shown) at the remaining hole in the landside, frog, and standard. Tighten the bolts securely.
3.Position the beam assembly over the standard and secure with two 1/13'x 2*h" hex bolts, lock washers, and hex nuts; tighten securely.
4.Install the beam assembly on the mast using two
9@,lrlock washers, and hex nuts.
NOTE: If the tractor rear wheels are set
in narrow tread position, position the beam as shown. If wheels are set wide. locate the beam asoutlined. ( S e e Width ofCut in
-'OPERATIONsection.)
5.Install the spacer between the mast arms at the bottom hole. Secure with a %If x
21/13" hex bolt, lock washer. and hex hut.
6.Install the link pins and secure them with %If hexjam nuts, lock washers. and hex nuts.
NOTE:Use holes
x 15" or larger tires: use holes
x12" tires.
BEAM ASSEMBLY
BOLTS.
LOCK WASHERS,
NUTS
CARRIAGE BOLT,
LAND ADJUSTING
BOLT, Ye" X 2%"
BEAM-
ASSEMBLV
Beam position/I | \ |
Beam position | |
with rear wheels | with rear wheels |
set for narrow | set for wide tread; |
tread; approx. 21" | tread; approx. 30" |
between tires. | between tires. |
HOLIE T
Use with 8.00 x 12" tires
