Honda Power Equipment PL752A, 3755790 manual Preparing Plow for Use

7.Insert the standard into the hub on the

.fork and secure it with the pin. Leave an equal amount of the pin extending on each side of the hub.

8.Assemble the coulter blade hub to the blade using three carriage bolts, flat

washers, hex lock nuts.

9.Assemble the fork and coulter with the axle, aligning the squares. Install two flat washers. and secure with the cotter pin. Bend the legs of the pin over the axle.

10.Mount the coulter/fork assembly on the left side of the plow beam using the clamp and U-bolt. Insert two spacers between the beam arms, then secure the U-bolt with 94" hex nuts: tighten the nuts securely.

After assembly, refer to PLOW

ADJUSTMENTS to set the coulter.

11. Install the hub on the gauge wheel using three !%// x 3/4't carriage bolts, plain washers, and hex lock nuts.

12.Install the flat washer on the hex bolt, insert the bolt through the hub. then add a second flat washer and the hex j a m nut. Secure with the lock washer and hex nut on the inside of the bracket as shown.

13.Mount the gauge wheel assembly on the plow beam standard using the short U-bolt and secure with 94" lock washers and hex nuts.

Preparing Plow for Use

After assembly, clean the moldboard with a ragsoaked in turpentine, kerosene or naphtha so that dirt will be less likely to stick to the protective coating. The coating can be removed with an old brick or a pumice stone, but this usually isn't necessaq unless the soil is too wet or stice.

-b Work in a well-ventilated area and handle cleaning materials with care. Wipe up any spilled liquid immediately and make sure the area is dry before starting the tractor.

SPACERS NUTS '

-STANDARD

C O U L T E ~BLADE

WASHER

HEX BOLT

h1WASHERS

BRACKET

LOCK WASHERS, If / / I