![](/images/new-backgrounds/1231043/23104343x1.webp)
TROUBLESHOOTING GUIDE
If you have followed the instructions contained in this manual and have difficulty in operating your TV/VCR locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to remedy the problem.
SYMPTOM |
| POSSIBLE CAUSE | CORRECTIVE ACTION |
No power. | . | AC Power cord is not connected. | . Connect AC power cord to AC outlet. |
| . | POWER switch on the back of the | . Set the POWER switch on the back of the |
|
| TV/VCR is set to OFF and/or | TV/VCR to ON and/or set the |
|
| FUNCTION button is set to OFF. | FUNCTION button to ON. |
No picture and sound. | . TV/VCR is not plugged into an | . Plug power cord into an active AC outlet. | |
| .. | active AC outlet. | . Check antenna connection. |
| Antenna is not connected. | ||
| No channel in memory. | . Program tuner’s memory. | |
No picture or poor | . Direction or condition of antenna | . Adjust direction or replace antenna. | |
picture on TV/VCR. |
| is not adequate. |
|
| . Picture control is not adequate. | . Adjust picture controls. | |
No sound or poor sound. | . Volume control on remote control | . Adjust volume control on remote control | |
|
| unit or main unit is in minimum | unit or set. |
|
| position. | . Press MUTE button. |
| . MUTE button on the remote control | ||
|
| unit is in the ON position. |
|
Timer recording is not | . The timer recording is set incorrectly. | . Set the timer recording correctly. | |
possible. | . | The timer recording is not set to ON. | . Set the timer recording to ON. |
Cannot go into Record | . The | . Place transparent tape over missing | |
mode. | . | is missing. | |
Playback picture is | The tracking control is not set | . Adjust tracking control for better picture. | |
partially noisy. |
| correctly. | . Head cleaning is necessary, consult the |
Noise in picture on | . Video heads are dirty. | ||
playback. | . No power to TV/VCR | nearest Service Centre. | |
No operation by infrared | . Make sure the AC cord is connected to | ||
Remote Control. | . Weak batteries. | an AC outlet. | |
| . Check the batteries in infrared Remote | ||
|
|
| Control. |
|
|
|
|
22