L=diwi!
The plow is correctlylanded when the running clearancebetween the lower links and the tiresis approximately equal, and the upper link extends straight behind the tractor.
The plow bottom reacts like a rudder while the ground is engaged. If the plow point is too far from the left of the beam, the plow will overcut and leave!a wed fimow wall. To adjust,loosen the bolts attaching the landside of the standard and turn the land adjusting bolt clockwise two turns. Retighten the attaching bolts. Repeat the adjustment, if necesmy, until the plow follows the tractor COrreCtly.
Leveling
With the tractor running in a previously plowed furrow at the desired depth and width of cut, stop the tractor with the plow in the ground and inspect the unit from the rear.
The standard should be near vertical from the ground. If it appears to lean to the right, raise the right side link by turning the rod clockwise, or lower the left side by turning its rod counterclockwise.Reverse the adjustments for a
coulter
The coulter should slice 2" - 3" deep. To adjust, loosenthe clamp securing the standard and raise or lower the forwstandard assembly.
Also, check the blade swing: It should be free to m n g outward a
LOOSEN THESE BOLTS
BEFORE ADJUSTING
LAND ADJUSTING BOLT
N
;
TOP VIEW
