Honda Power Equipment SLK7000K1 k/

OPERATION

Use the alignment bracket (as needed) to help vertically position the sulky’s hitch with the hitch bracket.

Typically, this procedure is necessary when a mower deck is mounted to the power unit, and the height

adjustment is set in the lower ranges.

1. Remove the spring clip and clevis pin from the

alignment bracket on the sulky’s crossbar.

As necessary, apply a small amount of general

purpose grease to the shank of the clevis pin.

2. Raise the alignment bracket up, then install the

clevis pin and spring clip in the side hole, so the

alignment bracket is held in the raised position.

3. Remove the lynch pin holding the adjusting lever

in the storage tube on the power unit. Remove

the adjusting lever from the storage tube.

4. Insert the adjusting lever into the alignment

bracket as shown.

5. Press the adjusting lever down enough to get the

hitch and hitch bracket holes to line up to allow

the clevis pin to drop all the way through.

6. Return the adjustment lever to the tube on the

power unit. Return the alignment bracket, clevis

pin and spring clip back to their original position.

ALIGNMEN

BRACKET

SPRING CLIP

BRACKET UP

ADJUSTING LEVER

Do not operate the sulky with the alignment bracket in the raised position. Damage to the sulky or the

lynch pin will occur. Always lower and lock the alignment bracket with the lynch pin before using the sulky.

SLK7000Kl SULKY