OPERATION BEFORE USING THE SULKY... Operating a Honda HRC7000series power unit is different when the sulky is attached. The unit is no
longer a “walk-behind machine” but is now “riding equipment.” This means it must be operated as a piece
of riding equipment and not a walk-behind machine. It is important for the operator to have some training
and be experienced with the operation of the HRC7000-series power unit before attempting to use it with
the sulky. Refer to the owner’s manual for your mid size commercial mower for details on power unit
controls and operation.
When connected to a mower deck, for example, a HRC7000series power unit is very maneuverable. The
use of the sulky does not specifically limit or reduce this, but there are some areas where operation is
different. Treat the machine like a piece of riding equipment and use sensible judgment during operation.
Inspection
Engage the parking brake, remove the ignition key and disconnect the spark plug cap(s) to prevent
accidental starting. Before you use the machine, inspect it closely. Follow the inspection procedure in the
“Before Mowing” section of your Mid Size Commercial Owner’s Manual, then use this section to inspect
the sulky.
l
Verify the clevis pin and lynch pin are properly installed on the hitch bracket.
l
Check the operation of the parking brake.
l
Make sure the tires are inflated to the proper pressure.
l
Examine the steering rod and make sure it is properly fastened to both the ball joint on the right hitch
bracket and the steering plate.
l
Inspect all nuts, bolts, and other hardware and make sure they are secure.
l
Verify that the alignment bracket is locked in the lower position, and the adjusting bar is stored on the
power unit.
Adjustments
The position of the seat can be adjusted for optimum operator comfort and control. Loosen the seat hitch
hardware (see page 26) and position the seat as desired. Torque the hardware properly after making an
adjustment.
12
SLK7000Kl SULKY