rPress Mode to exit the programming mode.
NOTE: If no button is pressed for 60 seconds, the thermostat will automatically exit the programming mode.
uPower Outage
In the event of a power outage, most settings are saved. Only the time must be
vTroubleshooting
PROBLEM | SOLUTIONS | |
|
| |
| This condition is normal. Under normal | |
Thermostat is hot. | operation, the thermostat housing can | |
reach a temperature between 95 °F | ||
| ||
| (35 °C) and 104 °F (40 °C). | |
|
| |
LO is displayed. | The measured temperature is below the | |
display range. Heating is activated. | ||
| ||
|
| |
HI is displayed. | The measured temperature is above the | |
display range. | ||
| ||
|
| |
Wrong temperature is | The thermostat is exposed to air draft. | |
displayed. | Eliminate the draft. | |
|
| |
Wrong time is displayed. | The thermostat was without power for | |
| more than 2 hours. | |
Temperature does not | Check that the thermostat is in Automatic | |
change according to the | mode. Check the schedule and clock set- | |
programmed schedule. | tings. | |
Display disappears and | The thermal protection device on the | |
reappears after a few | heater is open. This can happen after a | |
power failure or if the heater is obstructed | ||
minutes. | ||
by furniture or curtains. | ||
| ||
|
| |
Display looks faded | The heating system is less than the | |
when heating is acti- | required minimum load. This thermostat | |
vated | cannot be used below that rating. |
wTechnical Specifications
Power: 120/208/240 VAC, 60 Hz
Minimum load: 2 A (resistive only) 250 W @ 120 VAC 400 W @ 208 VAC 500 W @ 240 VAC
Maximum load: 16.7 A (resistive only) 2000 W @ 120 VAC 3500 W @ 208 VAC 4000 W @ 240 VAC
Display range: 32 °F to 140 °F (0 °C to 60 °C)
Display resolution: 1 °F (0.5 °C)
Setpoint range: 40 °F to 86 °F (5 °C to 30 °C)
Setpoint interval: 1 °F (0.5 °C)
Storage:
Certification: c UL us
;Warranty
Honeywell warrants this product, excluding battery, to be free from defects in the workmanship or materials, under normal use and ser- vice, for a period of one (1) year from the date of purchase by the consumer. If at any time during the warranty period the product is determined to be defective or malfunctions, Honeywell shall repair or replace it (at Honeywell's option).
If the product is defective,
(i)return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it, or
(ii)call Honeywell Customer Care at
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was caused by damage which occurred while the product was in the possession of a consumer.
Honeywell's sole responsibility shall be to repair or replace the product within the terms stated above. HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WAR- RANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY HONEY- WELL MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PUR- POSE, IS HEREBY LIMITED TO THE
This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
If you have any questions concerning this warranty, please write Hon- eywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call
Customer Assistance
If you have any questions about the operation of your thermostat, please go to http://yourhome.honeywell.com, or call Honeywell Customer Care
As an ENERGY STAR® partner, Honeywell has determined that this product meets the ENERGY STAR guidelines for energy efficiency.
08060 / TH106 / TL6061 | 1/11/06 | 3/3 | |
Programmable Thermostat - Installation and User Guide |
|
|
|