Honeywell 17005 owner manual Intelli-CheckTM, FilterMonitors, HowtoInstallandReplacetheFilters

Fig. 6b

Fig. 6a

Intelli-CheckTM

FilterMonitors

This air cleaner is equipped with Intelli-Check FilterTM Monitors to serve as a convenient guideline for replacement of the pre-filter and HEPA filter based on the air cleaner’s hours of use and operating speed. This is beneficial because a filter’s life depends on the amount of air and contaminants drawn through it. Each filter bar will fill up from clean to dirty as its expected filter life is used up. Once the bar is completely full, it is time to check / replace the filter.

•To move between the PRE-FILTER bar and the HEPA FILTER bar, quickly press the FILTER button (Fig. 6a).

•To RESET a filter bar that appears on the display, press and hold the FILTER button for 5 seconds, or until the filter bar clears to CLEAN status (Fig. 6b).

The Intelli-Check™Filter Monitors calculate the expected filter life based on an assumed average operating time of 12 hours a day on medium speed. Therefore, it will indicate replacement of the Pre-filter in about 3 months, and the HEPA filter in about 1 year and 9 months. Depending upon your individual usage (environment, hours and speed of operation), you may need to check and replace the filters more or less frequently.

PRE Filter Life HEPA

PRE Filter Life HEPA

HowtoInstallandReplacetheFilters

INSTALL PRE-FILTER BEFORE INITIAL OPERATION. The initial

pre-filter is packaged separately to ensure its freshness. BEFORE

Fig. 7

initial operation, locate the pre-filter in the package and install per the instructions (Refer to Page 2 “Construction” section).

DISCONNECT FROM POWER SUPPLY BEFORE SERVICING.

1.Unscrew locking mechanism counter-clockwise (Fig. 7).

2.Remove Endcap and remove filter assembly from unit (Fig. 8).

3.Undo fastener(s) and remove pre-filter.

4.As needed, replace HEPA Filter (there is no orientation to filter).

5.As needed, install new pre-filter by securing it around HEPA filter with the fastener(s) provided (Fig. 9).

6.Replace endcap.

7.Insert and tighten locking mechanism clockwise.

8.Discard used filter(s).

9.Plug in and RESET appropriate filter monitor(s) per instructions below.

•Press FILTER button until the PRE-FILTER or HEPA FILTER monitor you wish to reset appears on the display.

•Press and hold for 5 seconds, or until the filter bar clears fully to CLEAN status.

Fig. 8

Fig. 9