Installation Guide
2
ENGLISH
nLoosen the locking screw at the bottom of the thermostat. Note that the screw is
captive and cannot be removed from the wallplate.
oSeparate the thermostat from the wallplate as per Figure 1.
pPosition the wallplate against the wall and mark hole positions with a pencil.
NOTE: Levelling is for esthetics only and will not affect the performance of the
thermostat.
qDrill holes at the marked positions and insert supplied wall anchors.
rPass the wires through the large opening located at the bottom center of the wallplate
as per Figure 2.
sSecure the wallplate to the wall with supplied mounting screws as per Figure 3.
tConnect the wires to the terminals.
Wallplate installation
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power
before beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube,
do not place the old control in the trash. Contact your local waste
management authority for instructions regarding recycling and proper
disposal.
Figure 1
Figure 2 Figure 3
400-626-000-D (69-1968EFS-03 TH1000D_TH2000D installation manual).book Page 2 Thursday, April 16, 2009 3:31 PM