Panasonic AW-RC400 Introduction, Accessories, Precautions for use, Indoor Pan/Tilt Head AW-PH400

Indoor Pan/Tilt Head AW-PH400

Introduction

≥The stand-alone indoor pan/tilt head can be rotated through 300 degrees in the vertical direction and 400 degrees in the horizontal direction.

≥Operations can be performed at high speeds of up to 90 degrees per second.

≥Equipment such as a camera and lens with a total weight of 17.6 lbs (8 kg) can be mounted on the unit.

≥The camera can also be rotated using the AW-RL400 roll unit available as an option.

≥The shooting positions and settings for up to 50 positions can be registered as preset memory data.

NOTE

≥The AW-PH400 cannot be controlled from the AW-RP301, AW-RP305, AW-RP501, AW-RP505, AW-RP605 or AW-RP605A controller.

≥In order to protect the environment when the pan/tilt head is to be discarded at the end of its service life, ask a specialized contractor to dispose of it properly.

Accessories
Rotary arm	1
Camera mounting base	1
Rotary arm and camera base mounting screws (with flat washers)
M5!22 mm	7
Camera cable	1
Tally lamp	1
Tally mounting screws (M3!6 mm)	2
Blank panel for tally	1
Wire mounting screws (with flat washers, spring washers)
M4!8 mm	1
M4!6 mm	1
Hexagon key wrench	1
AC cable	1
Rubber piece	1

Precautions for use

The AW-PH400 uses a manganese dioxide-lithium battery (CR2032).

Before discarding the pan/tilt head or its printed circuit boards, be absolutely sure to remove the battery.

Be absolutely sure to dispose of the removed battery in accordance with the applicable domestic laws and regulations.

Do not throw out the battery along with the general household garbage.

For the procedure to remove the battery, refer to the section on replacing the battery in “Replacing the consumable parts” (page 19).

Replace the lithium battery here.

6