Panasonic AW-RP400 $ Front panel, = ? @ A B C D, E F G H, 1EXT CONT M/S switch, OPERATE lamp

Pan/Tilt Control Panel AW-RP400

Parts and their function

$ Front panel	; < = > ? @ A B C D	E F G H I	1
2
3
4			J	AW-RP400
6			K
5
7
8
9
:			L

1EXT CONT [M/S] switch NOTE

This switch is normally kept at the [M] (master) position. When an additional AW-RP400 control panel has been installed, set the EXT CONT switch on the additional unit to [S] (slave).

If no additional AW-RP400 control panel is going to be installed, the EXT CONT switch on this control panel must be kept at the [M] (master) position without fail.

2OPERATE lamp

This lights up green when the (3) OPERATE switch is at ON. It goes off when the switch is set to OFF.

3OPERATE [OFF/ON] switch

When this switch is set to [ON], the power supply from the connected pan/tilt heads to the cameras is turned on, and system control is enabled.

When it is set to [OFF], the power supply from the connected pan/tilt heads to the cameras is turned off.

≥The centering of the joystick and zoom switch is adjusted when the OPERATE switch has been set to [ON]. Therefore, do not touch the joystick or zoom switch while this switch is at the [ON] position.

≥When an additional AW-RP400 control panel is installed and used, it will not be possible to exercise control from the slave control panel unless the OPERATE switches not only on the slave control panel but on the master control panel as well are set to [ON]. Remember to set the OPERATE switch on the slave control panel to [ON] first before setting the OPERATE switch on the master control panel to [ON].

4INCOM jack

The INCOM (inter-communication) headset is connected here.

5LEVEL control

Use this to adjust the volume of the headset’s receiver.

6CALL button

When this button is pressed, the buzzer of the connected control panel sounds, and the CALL button lamp lights.

23