Stylus

Optimus 5900 RFID terminals ship with a stylus inserted in handle. Store the stylus in the handle when you are not using it; see Using the Stylus on page 2-5.

Right Side Panel Features

Micro SD Slot

Side Button

Side Button

There is a button like this on both side panels. You can use the Programs Buttons option in the Control Panel to change the functionality of the side buttons.

Side DoorThe rubber door on the left side panel provides access to the Micro SD slot.

When closed, the side door seals the terminal from moisture and particle intrusion thus preserving the terminal’s environmental rating.

Installing Memory Cards

The Optimus 5900 RFID supports Micro Secure Digital High Digital (SD) memory cards up to 32GB.

To install an SD card

1.Press the Power key to put the terminal in Suspend Mode; see Suspend Mode on page 3-15.

2.Open the access door on the left side.3.Insert the SD card with the label facing upward.

Note: To remove an installed SD card while the access door is open, tap on the edge lightly to unlock the card; the card will pop out just enough for you to grab its edge and pull it out.

4.Replace the access door.

The rubber door is required for 1) proper functioning of the SD card and 2) preserving the environmental rating for water sealing. Do not remove the rubber door.

Note: Do not use the terminal when the access door is open. When this door is fastened securely and properly, the memory interface is sealed against moisture and particle intrusion, read/write data is stored securely, and the terminal’s environmental rating is preserved.

5.Tap the Power key to resume operation.

6.To verify that the operating system recognizes the new memory card, open Windows Explorer and navigate to My Device\Storage Card.

3 - 8