INSTALLATION
Keyboard Wedge
1.Turn off the host device.
2.Plug the male
3.Disconnect the keyboard from the host device.
4.Connect the “Y” end of the PowerLink cable to the keyboard and the keyboard port on the host PC. If necessary use the male/female adapter cable supplied with the scanner for proper connections.
5.Plug the external power supply into the power jack on the PowerLink cable.
|
| Check the AC input requirements |
|
|
|
| of the power supply to make sure |
|
|
|
| the voltage matches the AC |
|
|
|
| outlet. The outlet must be |
|
|
|
| located near the equipment and |
|
|
|
| be easily accessible. |
| Figure 11. |
6. | Connect AC power to the transformer. |
| ||
7. | Turn on the host device. |
|
When the scanner first receives power, the blue and white LED will toggle on and off then the scanner will beep once.
Powering the 7180 directly from the host device can sometimes cause interference with the operation of the scanner or the computer. Not all computers supply the same current through the keyboard port. For this reason, Honeywell recommends using an external power supply. For additional information contact a customer service representative.
See page 5.
9