INSTALLATION

RS232, Light Pen Emulation

1.Turn off the host device.

2.Plug the male 10-pin RJ45 end of the PowerLink cable into the 10-pin socket on the 7180.

3.Connect the 9-pin female end of the PowerLink cable to the host device.

4.Plug the external power supply into the power jack on the PowerLink cable.

Check the AC input requirements of the power supply to make sure the voltage matches the AC outlet. The outlet must be located near the equipment and be easily accessible.

5.Connect AC power to the transformer.

6. Turn on the host device.

Figure 9.

 

When the scanner first receives power, the blue and white LED will toggle on and off then the scanner will beep once.

Plugging the scanner into the serial port of the PC does not guarantee that scanned information will appear at the PC. A software driver and correct configuration setting may be required for proper communication to occur.

Powering the 7180 directly from the host device can sometimes cause interference with the operation of the scanner or the computer. Not all computers supply the same current. For this reason, Honeywell recommends using an external power supply. For additional information contact a customer service representative.

See page 5.

7