INSTALLATION

Full Speed USB

1.Turn off the host device.

2.Plug the male 10-pin RJ45 end of the USB cable into the 10-pin socket on the 7180.

3.Plug the other end of the USB interface cable into the host device’s USB port.

4.Turn on the host device.

When the scanner first receives power, the blue and white LED will toggle on and off then the scanner will beep once.

Figure 13.

As a default, the MS7180-38leaves the factory with USB Keyboard Emulation Mode enabled. Scan the following bar code to configure the MS7180-38 for USB Serial Emulation Mode.

³ 3 1 6 4 6 0

Plugging the scanner into the USB port of the PC does not guarantee that scanned information will appear at the PC. A software driver and the correct configuration settings are also required for proper communication to occur.

For Previous User’s of the 7120 Orbit* with an MX009:

The following bar code must be scanned in order for the new integrated USB 7180 OrbitCG to function with the same serial emulation driver as the old external USB 7120.

³ 3 1 6 4 7 0

* Orbit models before the 7120 rev L.

11