TOA Electronics C-AL80(H), C-AL80(L) Mode Selection Switch Settings, Alarm/Remote Input Settings

5. MODE SELECTION SWITCH SETTINGS

Perform settings of Alarm/Remote input, and alarm intervals here.

Note

Make sure that the Power switch is set to OFF when setting each Mode Selection switch. The Mode switch is not correctly set if the Power switch is set to ON.

5.1. Alarm/Remote Input Settings

Using Mode Selection switch 1, select either "Alarm" or "Remote" for Alarm/Remote input. Set the switch to the lower "Alarm" position when selecting "Alarm," and to the upper "Remote" position when selecting "Remote." The "Alarm" position permits alarm indication to be displayed and a buzzer to be sounded when there is an alarm signal input. However, when a master/slave connection is established, only the master unit's setting is valid. (Factory-preset position: Alarm)

LEVEL
REMOTE OFF
ABBREVIATION No.9001
REMOTE
ALARM
	1 2 3 4
ABBREVIATION No.1
REMOTE ON
EDGE

REMOTE

ALARM
	1

5.2. Abbreviation Number Settings

Please fix to the "Abbreviation No. 1–," (Factory-preset position: "Abbreviation No. 1–,")

In the event of the slave unit, its abbreviation number increases in increment of 32. Thus, each Alarm Unit's Alarm/Remote inputs 1 – 32 correspond to the abbreviation numbers shown in the below table.

ABBREVIATION No.9001

ABBREVIATION No.1

2

• Alarm/Remote input Nos. 1 – 32 vs. corresponding abbreviation Nos.

Master Unit's	Master	Slave	Slave	Slave	Slave	Slave	Slave	Slave
Switch Setting	Unit 1	Unit 2	Unit 3	Unit 4	Unit 5	Unit 6	Unit 7	Unit 8

			1	32	33	64	65	96	97	128	129	160	161	192	193	224	225	256
1	2	3	4

Note

The C-AL80 uses the abbreviation numbers to perform alarm activation or remote control for the Remote Control. Therefore, the abbreviation numbers must be preprogrammed into the Remote Controller.

7