[Rear Panel]
711
ALARM/ / REMOTE IN
MASTER / SLAVE
OFF ON
TERMINATION
CAMERA SELECT OUT | ALARM / REMOTE OUT |
5 | 6 | 8 | 9 | 10 |
(5) Power Inlet
Connects to the supplied power supply cord.
(6)Alarm/Remote Input Terminal [Alarm/Remote Input]
Use the Mode Selection switch (4) to perform input function settings. When set to "Alarm" input, an alarm can be activated from such external devices as sensors connected to this terminal. When set to "Remote" input, this terminal permits the selection of the camera connected to the Remote Controller. (Refer to p. 11; Using the Alarm/Remote Function.)
(7)Master/Slave Terminal [Master/Slave] (Non LPS)
These input and output terminals are used to make master/slave connections for multiple
(8)Camera Selection Output Terminal [Camera Selection Output]
It cannot be used.
(9)Alarm/Remote Output Terminal [Alarm/Remote Output]
It cannot be used.
(10) RS-232C Terminal [RS-232C] (Non LPS)
Connects to the Remote Controller's
(11) RS-485 Termination Switch [Termination]
Used for master/slave connection of multiple
6