Honeywell 7850 Inserting and Removing Terminals, Supplying Power to the ChargeBase, The LEDs light as the base powers up, Plug the power cord into the power adapter

Supplying Power to the ChargeBase

!	Use only the peripherals, power cables, and power adapters from Honeywell. Use of peripherals, cables, or
	power adapters not sold/manufactured by Honeywell may cause damage not covered by the warranty.
1.	Be sure the power switch on the power adapter is in the OFF position.
2.	Plug the power cord into the power adapter.
3.	Plug the power connector cable into the power connector on the back panel of the base.
4.	Plug the power cord into a standard wall outlet.
5.	On the power adapter, turn the power switch to the ON position.
	The LEDs light as the base powers up.
6.	The base is ready to begin charging terminals.

Inserting and Removing Terminals

To insert a terminal, hold the terminal with the bottom panel perpendicular to the base. Slide the terminal into the well until the Dock LED lights solid green. Charging begins immediately.

To remove a terminal, grasp it firmly in your hand and lift it up and out of the terminal well. The LEDs for the terminal well turns off.

11 - 4