SETTING UP THE WINE CHILLER
UNPACKING
Remove all packing materials and accessories. Examine the chiller for any damage such as dents or broken door. Do not install if chiller is damaged.
NOTE: Allow the wine chiller to stand upright for approximately 24 hours before connecting the power source. This will let the compressor settle from being handled during transportation.
Starting the wine chiller too soon and not allowing the compressor to settle can result in a lack of cooling.
Please make sure the following parts are included:
1)6 wire shelves
2)1 bottle/can wire basket
3)1 instruction manual
If discarding an old chiller, please see “Important Safety Instructions” on page 3.
LOCATION OF THE CHILLER
Find a suitable area for your wine chiller.
•Do not place the chiller outside and under direct sunlight, or any other place where the chiller will be exposed to water or other harsh weather conditions.
•Direct sunlight and other heat sources may cause over power consumption.
•Do not placed in environments where the ambient temperature drops below 50°F (10°C) degrees as the unit will not perform properly.
•Make sure to place the wine chiller on a floor that is strong enough to support it when fully loaded.
INSTALLATION INSTRUCTIONS
The wine chiller is a free standing appliance and can be installed next to counters and walls. It must not be placed under a counter.
For the chiller to function properly, it is important to have a clearance of at least 5” inches (13 cm) from the back of the chiller to the surface next it. A clearance of at least 5” inches (13 cm) is required from each side of the chiller to the surface next to it.
5” inches / 13 cm |
|
wall |
|
| 5” inches / |
back | 13 cm |
Top of |
|
the chiller |
|
front |
|
6
