Remote Control of OSD from PC
3.Unpack the zip file into an appropriate folder.
4.
5.Ensure that the COM port you connected the RS485 converter to is selected. See the figure below.
6.Click OK to initialize Communication (this can take up to 20 seconds).
7.If Communication failed you can:
a.Check the wiring and power connections of the camera, or
b.Click Retry to initialize Communication again, or click End to close the window.
8.If Communication is successful, the following window will appear. See the next sections for remotely controlling your HCC484TP Camera.
Rev 1.00 | 2 | D002529 |
|
| 04/06 |