ANN-RLY Relay Module

Installation Instructions

The ANN-RLY relay module provides 10 programmable Form-C relays when used with a compatible FACP (Fire Alarm Control Panel). This document is provided as a quick reference. For more detailed information, refer to the appropriate FACP installation manual.

Note: Installation and wiring of this device must be done in accordance with NFPA 72 and local ordinances.

Specifications

Table 1: ANN-RLY Module Specifications

Operating Voltage

 

24 VDC

 

 

 

Max. Current @

Alarm

75 mA

24 VDC

 

 

 

 

Standby

15 mA

 

 

 

 

 

Operating Temperature

0o to 49o C

 

 

 

(32o to 120o F)

 

 

 

Max. Wiring Distance from

1,250 ft.

FACP (with 12 AWG wire)

(380 m)

Relay Contact Ratings

2 amps @ 30 VDC

 

 

 

(resistive)

 

 

 

 

 

 

 

0.5 amps @ 30 VAC

 

 

 

(resistive)

Indoor Use in Dry Location Only

Mounting in FACP Main Board Chassis

ANN-RLY module standoffs

R1

R3

R5 (top)

R7

R9

 

R1

R3

R5

R7

R9

ground

 

 

 

 

 

R2

R4

R6 (bottom) R8

R10

wire

 

ANN-RLY module mounting hooks

 

1.Install the two supplied snap-in standoffs into the backside of the ANN-RLY circuit board in locations indicated in illustration above.

2.Using supplied hardware, attach the ground wire using a screw and nut to location indicated in illustration above. Be sure to position the ground wire as shown to facilitate ANN-RLY installation.

3.Position the ANN-RLY module in the chassis so that the two standoffs in the module are posi- tioned over the wider portion of the mounting holes in the chassis and the mounting hooks on the module are sticking through the module mounting slots in the bottom of the chassis.

4.Slide the ANN-RLY module to the right to lock the module into place.

5.Attach the ground wire installed in step 2 to the chassis in the location indicated below.

chassis

Mounting

The ANN-RLY module may be mounted inside the FACP main circuit board chassis or in the battery area of the enclosure using mounting bracket P/N: ANN-MBRLY. Refer to the following illustrations for installation information.

Note:

1. ANN-RLY module can be installed without removing the main circuit board or chassis.

2. ANN-MBRLY mounting bracket must be used for the MS-9200UDLS.

ANN-RLY module mounting holes

ANN-RLY module

ground

mounting slots

 

wire

ANN-RLY Module Document # 53033 Rev. B 10/10/07 ECN 07-744

1