Mounting in FACP Main Board Chassis Using the ANN-MBRLY bracket

1.Placing the ANN-MBRLY mounting bracket flat against the inside back wall of the FACP backbox, position both bracket mounting tabs above the two embossed protrusions in the backbox and slide the tabs down into the protru- sions as illustrated below.

3. Install the ANN-RLY Relay Module on the ANN-MBRLY mounting bracket by positioning the four module mounting holes over the four standoffs on the mounting bracket.

4. Install one of the four supplied mounting screws and the supplied grounding strap in the top left mounting hole of the ANN-RLY module as illustrated below.

5. Secure the ANN-RLY module to the ANN-MBRLY bracket with the remaining three supplied mounting screws and tighten all mounting screws.

6. Attach the other end of the grounding strap to the backbox grounding stud, securing it with a nut as illustrated below.

ANN-MBRLY

Mounting Bracket

embossed tab protrusion

embossed tab protrusion

FACP Backbox

2.Secure the ANN-MBRLY mounting bracket to the backbox by installing the supplied self-tapping screw into the top embossed protrusion/tab as illustrated below.

self-tapping

screw

embossed protrusion

FACP Backbox

grounding stud

mounting screws

grounding strap

ANN-RLY Module

mounting screws

FACP Backbox

IMPORTANT! Only 7 AH or 18 AH batteries will fit in the FACP backbox when the ANN-MBRLY mounting bracket is installed. If 12 AH batteries are to be used, they must be installed in an external UL listed battery box such as the BB-17F.

2

ANN-RLY Module Document # 53033 Rev. B 10/10/07 ECN 07-744