Honeywell HA40 Changing Menu Variables Using the Keypad, Setup Configuration Menus

HA40 4-Channel Controller

2.2Changing Menu Variables Using the Keypad

				Magnetic
Cal	Next	Edit	Alarm	Keypad
			Reset	(Keypad buttons
				behind door)

Upon entering a menu, a pointer controlled by the Up/down arrows keys points to the selected variable. Some are simple YES/NO or ON/ OFF entries toggled by pressing the Edit key. Others, such as Channel ID and Eunits fields may have many ASCII character possibilities. Allowed ASCII characters are as follows:

ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`abcdefghijklmnopqrstu vwxyz blank space”#$%&`()*+,-./0123456789:;<=>?@.

Notice the often used blank character is located after lower case z and before the exclamation point !. Edit places a cursor under the item and Up/down arrows scroll through each allowed entry. The Next key moves the cursor to the next position within a field. When the field is complete, Edit clears the cursor and loads the field into non-volatile memory where it is retained indefinitely. Without a cursor present, the Next key closes open menus in reverse order and returns the LCD to the data display.

2.2.1 Setup Configuration Menus

The SETUP menu (shown in the middle of Figure 2-16 and in Figure 2-17) is accessed by pressing Edit when any data display is present. This is the entry-level screen to all Channel, System and Security menus. It also shows the firmware version operating in the HA40. Use the up/down arrow keys to move the pointer to the desired menu and press the Edit key.

SETUP (firmware rev)

Channel 1

Channel 2

Channel 3

Channel 4

System

Security

History

Figure 2-1. Setup Configuration Menu

2.2.2 Channel Setup Entry Menu

The Channel x SETUP menu shown in Figure 2-18 allows configuration of all variables for the selected channel. These are Fault, Alarm 1, Alarm 2, Alarm 3, Configure and CAL Setup.

Figure 2-2. Channel Setup Entry Menu

HA40 Technical Manual 2-3 Revision 1 (07/08)