Honeywell HFD110 Never place a wet ifD Micro-filter in your air purifier, To clean the pre-filter

REMOVING / CLEANING THE IFD™ MICRO-FILTER FOR ALL MODELS FILTER (CONTINUED)

•Note that the filter may still be discolored even after washing. This is acceptable and will not affect performance.

•Allow the ifD™ Micro-filter to dry for a few hours or overnight.

•When the ifD™ Micro-filter is completely dry, place back into the air purifier. Make sure you insert the filter according to the directional arrows on the filter.

CAUTION:

•Never place a wet ifD™ Micro-filter in your air purifier.

•Do not use any solvents, strong cleaning agents or flammable liquids to clean the ifD™ Micro-filter.

CLEANING THE WASHABLE PRE-FILTER (ALL MODELS)

To remove the pre-filter:

Press the top tab to release the pre-filter from the filter assembly (Fig. 14).

To clean the pre-filter:

The particle pre-filter helps pick-up large airborne particles that enter the filter. The pre-filter can be removed and rinsed by hand under warm water (Fig. 15). Let the pre-filter dry completely before inserting it back into the unit.

Fig. 14

Fig. 15

Some models are shipped with bonus odor control pre-filters that are not washable. After the pre-filters have lost their odor reducing capability over time (approximately 3 months), you can order replacement Odor-Lock™ pre-filters by calling the Kaz USA, Inc. Consumer Relations Department at 1-800-477-0457.

INSTALLING THE ODOR-LOCK™ PRE-FILTER(S) (HFD-014 ONLY)

• To replace the permanent, washable pre-filters with the		Fig. 16
Odor-Lock™	pre-filters, remove the standard washable
pre-filter assembly by pushing on the top tab (Fig.16).

•The pre-filter assembly has two pre-filters that will need to be popped out of the pre-filter frame. Hold the frame steady from the side while pushing in the center of each pre-filter from the back side of the frame (Fig.17). This

	will separate the pre-filter from the frame and you can
			Fig. 18
	then pull it completely away from the frame (it will snap
	out) (Fig.18). Save the permanent washable pre-filters
	as you may choose to use them in the future.*
•	To insert the Odor-Lock™	pre-filters into the pre-filter
	frame, line the tabs on the pre-filter up with the frame
	notches and snap into place (Fig.19).
•	Install the Odor-Lock™	filter assembly by inserting the
			Fig. 20
	lower tab of the pre-filter frame into the filter assembly
	until you hear a “click” (Fig. 20).

•Align the complete filter assembly with the opening in the unit and insert back into the unit (Fig. 21).

NOTE: The Odor-Lock™ filters are not washable.

Fig. 17

Fig. 19

Fig. 21

6