Installing the NetAXS-123 Panels
Installation
NetAXS-123 Access Control Unit Installation Guide, Document 800-05779, Revision A 31
Notes:
• The Controller Board includes Inputs 7 and 8 but they are reserved for system use. • The Controller Board also includes Output 5, a general-purpose output, and Output 6, which is reserved by the system to control the boards’ RUN LEDs and thus is unavailable for user control.• Reader LED, while it is an output, should never be used to control anything other than its associated reader’s LED.Tabl e 6 lists the factory I/O board default settings for a door 2. These mappings should be used for the readers, inputs, and outputs when either a 1- or 2-door Add-On Board is attached to the board-to-board connector on the Controller Board.Table 6: Factory Default Configuration Settings for Door 2
a Readers A and B share the same connection.
Type Purpose Web
Default
Name
Terminal
Block
Label
Reader A Reader B Other
Input Egress/
Request to
Exit (REX)
Input 9:
Door 2
Egress
IO-TB2
IN9 (REX)
Input 9aInput 9a
Door Status Input 10:
Door 2
Status
IO-TB2
IN10 (STS)
Input 10aInput 10a
Reader
Tamp er
Input 11:
Door
TMPR-A
IO-TB3
TMPR A
Input 11
Reader
Tamp er
Input 12:
Door
TMPR-B
IO-TB4
TMPR B
Input 12
Output Lock Relay Output #7 IO-TB1
LOCK
Output 7aOutput 7a
Reader LED Output #8 IO-TB3
LED
Output 8aOutput 8a
AUX Relay Output #9 IO-TB1
AUX
Output 9
Reader
Buzzer
Future
Feature
IO-TB3
BZR
Output 10aOutput 10a