8.Press <Enter> for Setup Mode
9.The following screen should appear.
10.Your Choice? Enter 0 for server configuration.
11.IP Address: (000) XXX.XXX.XXX.XXX <Enter>
12.Set Gateway IP Address
Type Y, if a gateway is needed. XXX.XXX.XXX.XXX (Gateway Address) Type N, if a gateway is not needed This number may or may not be needed. Check with the MIS department to verify if the Ethernet Card will need a gateway programmed.
13.Netmask: Number of Bits for Host Part (0=default to Class C) (00) Type 8, 16, or 24 depending on the subnet mask class being used.
Class A: 24 = subnet of 255.0.0.0
Class B: 16 = subnet of 255.255.0.0
Class C: 8 = subnet of 255.255.255.0
14.Change Telnet Config Password (N) <Enter> No password needed.
