PROGRAMMING ETHERNET DEVICES
This covers all of the steps needed to get the PRO22EN Ethernet Daughter board
PRO22EN Programming
The PRO22EN will be programmed from a Command Prompt using the ARP command. ARP (Address Resolution Protocol), a TCP/IP protocol used to convert an IP address into a physical address (called a DLC address), such as an Ethernet Address. A host wish- ing to obtain a physical address broadcasts an ARP request onto the TCP/IP network. The host on the network that has the IP address in the request then replies with its physical hardware address (MAC address).
EQUIPMENT NEEDED
1.PRO22IC (Intelligent Controller)
2.PRO22EN (Ethernet Card and Mounting Kit)
3.A Networked Computer.
4.A Network Crossover cable to connect directly to the PRO- 2200 or a Network Connection that is on the same network segment as the
Special Note: When programming the Ethernet card verify that you’re not initially going through a gateway or a router. When programming is complete the unit can be installed on a different network segment.
HARDWARE SETUP
1.Prior to mounting the PRO22EN onto the PRO22IC verify the MAC address on the back of the PRO22EN (Ethernet Card). This address will be needed during programming of the card with the correct IP Address, Subnet Mask, and Gateway.
Example: MAC Address
Static IP Address___________________________
(Check with MIS\IT Department)
Subnet Mask _______________________________
(Check with MIS\IT Department)
Default Gateway_____________________________
(Check with MIS\IT Department)
