Honeywell ST 3000 manual 77

A.5 Configuring Smart Meter Using Pushbuttons, Continued

Setting lower display values, continued

Table A-7 Setting Lower Display Values for Smart Meter Display, continued

Step	Action		Meter Display
9	Press Increase ￿ button to select the next	Third digit value setting.
	available digit value or Decrease ￿ button to
	select the previous digit value.
	Repeat this action until desired value is on	VAR						UPPER
	display.
		SEL.						VALUE
		0					100
			%
			0 .00					UNITS
								S E T
10	Press LOWER VALUE button to lock-in third					ANALOG
								LOWER
	digit and activate next active digit.
								VALUE
	Readout now displays next active digit which
	will be BLANK unless lower value was set to 1	Press and hold to						Press and hold to
		scroll backward
	before.				0			scroll forward
		through values						through values
			1
11	Press Increase ￿ button to set digit to 1 or		2
			3
	Decrease ￿ button to set it to BLANK..
			4
			5
12	Press LOWER VALUE button to lock-in “1”		6
			7
	digit and activate sign segment.
			8
	Readout now displays sign segment which			9
	will be BLANK for positive values unless lower
	value was set for negative (–) values before.
13	Press Increase ￿ button to set sign segment	Sign segment setting.
	to minus sign for negative values or Decrease

￿button to set it to BLANK. for positive

	values.
14	Press LOWER VALUE button to lock in			SEL.			VALUE
	current settings as lower display value limit.			VAR			UPPER
				0	%	100
					0 .00		UNITS
							S E T
			For CUSTOM unit in				VALUE
		ATTENTION			ANALOG
							LOWER
	transmitter with LINEAR output, you must set
	both lower and upper display limits for values			Press to set sign
	to take effect. If you let either the lower or						Press to set sign
				segment as
	upper display limit time out (after 30 seconds),			BLANK for			segment as minus
							sign (-) for negative
	the meter discards both newly set values and			positive values			values
	reverts back to the previously set values.

•If you have not yet set the upper display limit value, the meter automatically enters the upper display setting function after it displays previously set value, if applicable. Go to Table A-8.

•If you have already set the upper display limit value, this completes the lower and upper display limits setting function for Custom engineering units in the transmitter. Meter returns to normal operation.

Continued on next page

2/05 ST 3000 Release 300 Installation Guide 67