Installation, Location | Honeywell T8775C instruction

INSTALLATION INSTRUCTIONS

	The T8775A,C Thermostats provide single-stage	Location
	temperature control for 24V systems. The	Install the thermostat about 5 ft (1.5m) above the
	T8775A,C models include a thermostat, wallplate
		floor in an area with good air circulation at average
	(for wiring and mounting thermostat), mounting
		temperature. Do not install the thermostat where it
	screws, wall anchors, and a 4074 FAB resistor.
		can be affected by:

		— drafts or dead spots behind doors and in
	MERCURY NOTICE	corners.
		— hot or cold air from ducts.
	If this control is replacing a control that	— radiant heat from the sun or appliances.
		— concealed pipes and chimneys.
	contains mercury in a sealed tube, do not
		— unheated (uncooled) areas such as an outside
	place your old control in the trash.
		wall behind the thermostat.

	Contact your local waste management	Mounting Wallplate to Wall
	authority for instructions regarding
	recycling and the proper disposal of an old	Mount the T8775A,C wallplate, with the screws
	control containing mercury in a sealed
		provided. See Fig. 1.
	tube.

INSTALLATION

1.Read these instructions carefully. Failure to follow them could damage the product or cause a hazardous condition.

2.Check the ratings given in the instructions and on the product to make sure the product is suitable for your application.

3.Installer must be a trained, experienced ser- vice technician.

4.After installation is complete, check out prod- uct operation as provided in these instruc- tions.

CAUTION

Electrical Shock or Equipment Damage Hazard.

Can shock individuals or short equipment circuitry. Disconnect power supply before installation.

WIRING HOLE
1 INCH SCREW (2)	M19499

1WHEN USING WALL ANCHORS, DRILL 3/16 IN. HOLES FOR DRYWALL, 7/32 IN. HOLES FOR PLASTER.

® U.S. Registered Trademark

69-1677EF