Honeywell TE22W Manual Settings, Setting the Alarm, Snooze, Disabling Alarm, Precautions

MANUAL SETTINGS
TIME ZONE
• Press MODE button to select time of day with day of the
•	week display mode.
	Select the Time Zone by pressing and holding the UP ( )
•	button for 3 seconds.
	Keep holding UP ( ) button until the desired time zone
	(Pacific, Mountain, Central or Eastern) is highlighted on
	the main unit’s display map.

CLOCK

• Press and hold MODE button for 3 seconds: the year digits will flash.

• Press UP ( ) or DOWN ( ) to change flashing digits.

• After the first value is set, press MODE button again to confirm.

• Continue setting month, date, 12 or 24 hour time format, hour, minute, day of the week display language and Fahrenheit or Celsius display.

• Press MODE for the last time to return to the default mode

(time of day with seconds) after the last parameter is set.

ALARMS

Weekly Alarm ( W )

The alarm will sound and the alarm icon will flash at the set time Mondays through Fridays.

Single Day Alarm ( S )

The alarm will sound and the alarm icon will flash at the set time, but will not activate on subsequent days.

Low Temperature Pre-Alarm for remote location (PRE-AL) If the remote temperature reaches 32º F (0º C) or below, the pre-alarm feature will be activated. The pre-alarm time interval can be set for 15, 30, 45, 60, 75 or 90 minutes earlier than the day of the week or single alarm time. Press and hold ALARM button for two seconds in Pre-Alarm mode to set the pre-alarm interval.

W (Weekly alarm), S (Single day alarm), and PRE-AL(Pre-alarm) icons will indicate which alarm mode is armed. You can enable or disable an alarm by pressing the UP ( ) or DOWN ( ) buttons in the selected alarm display mode. Press ALARM button to toggle between alarm modes or to return to the default display.

11

SETTING THE ALARM

To set any alarm,

• Press ALARM button once to display alarm time. If the alarm is off, OFF will be displayed.

• Press and hold ALARM button for two seconds. The hour digit will flash.

• Enter the hour using DOWN ( ) or UP ( ).

• Press ALARM button again. The minute digits will flash.

• Enter the minutes using DOWN ( ) or UP ( ).

• Press ALARM button again to exit.

• Repeat the same procedure to set a Single and Pre-Alarm.

SNOOZE

When the alarm sounds, press the SNOOZE button to temporarily stop the alarm. After the SNOOZE is depressed, the alarm sound will resume in five (5) minutes.

If the alarm is not disabled after that, it will sound for four (4) more minutes and then will stop by itself.

DISABLING ALARM

Press ALARM button on the main unit to disable any of the alarms.

When Weekly, Daily or Pre-Alarm is disabled, an applicable icon W , S , or Pre-Al will disappear from the main unit’s display.

PRECAUTIONS

This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions:

1.Do not immerse the units in water.

2.Do not clean the units with abrasive or corrosive materials. They may scratch the plastic parts and corrode the electronic circuits.

3.Do not subject the product to excessive force, shock, dust, temperature, or humidity, which may result in malfunctions, shorter lifespan, damaged batteries, and damaged parts.

4.Do not tamper with the units internal components. Doing so will invalidate the warranty and may cause damage. These units contain no user-serviceable parts.

5.Use only fresh batteries. Do not mix new and old batteries.

6.Read the user's manual thoroughly before operating the units.

12