•Make sure the main unit is positioned at 8 feet (2 meters) distance from any interference source such as a TV, computer monitor, microwave, etc.
•Within concrete wall rooms such as basements or office buildings, the received signal may be weakened. Always place the unit near the window for better reception.
MAXIMUM AND MINIMUM READINGS
The maximum and minimum record of the indoor and remote temperatures will be automatically stored in the memory of the main unit (receiver).
To display the minimum, maximum or the current reading press MEM button.
If no button is pressed for the next 15 seconds, the unit will return to the current temperature display.
To clear the memory, press and hold MEM button for two seconds and all previously stored readings will be erased.
TEMPERATURE TRENDS
The temperature trend indicators located on the indoor and remote temperature information lines show the trend of temperatures collected indoors and at particular remote sight. There are three trends that can be displayed: Rising, Steady, and Falling.
LOST COMMUNICATION
If the main unit display line for the remote sensor reading goes blank, press and hold DOWN ( ) button for 2 seconds to begin a new signal search. If the signal still isn’t received, please make sure that:
1.The remote sensor is in its proper location.
2.The distance between main unit and remote sensor is not over 100 feet (30meters).
3.The path between units is clear of obstacles. Shorten the distance if necessary.
9
4. Fresh batteries are installed correctly in both remote sensor and main unit.
If there is no reception, please perform the following steps:
1. Bring the main unit and remote sensor close together.
2. Remove four (4) small screws from the back of the remote sensor with small Phillips screwdriver, and open the battery compartment.
3. Remove the batteries from the battery compartment and reinstall them in the same manner. Remote sensor LED indicator will flash showing transmission of the signal.
4. Remove the batteries from the main unit and reinstall them in the same manner.
5. The remote temperature appeared on the main unit’s display will show that transmission is being received successfully.
TRANSMISSION COLLISION
Signals from the other household devices such as wireless doorbells, home security systems, and entry control, may interfere with this product or cause temporary reception interruption. This is normal and will not affect the general performance of the product. The transmission and reception of the temperature readings will resume once the interference subsides.
ATOMIC CLOCK
After the main unit receives information from the remote sensor, the atomic time signal receiver will start to search for the time signal. It usually takes between 
] icon will appear under the US Time Zone Map icon.
If the time signal has not been received in 8 minutes, press MODE button to set the time and date manually.
After the unit is set manually, place it by the window for the better reception. The unit’s atomic clock receiver is programmed that it will continue to search for the atomic time signal daily for every hour between 1:00 am and 4:30 am. Once the time signal has been successfully received, the time and date will be updated automatically.
CALENDAR AND CLOCK DISPLAY MODES
Date is displayed in
the time of day with seconds and time of day with the day | |
of the week. | 10 |
| |
