| OVER | Contains excess | ||
WET | (23°F | |||
70%RH | moisture | |||
| to122°F) | |||
|
|
| ||
| 5°C to 50°C | BELOW | Contains inadequate | |
DRY | (23°F | |||
40%RH | moisture | |||
| to122°F) | |||
|
|
|
MAXIMUM AND MINIMUM READINGS
The maximum and minimum record of the indoor and remote temperature and humidity will be automatically stored in the memory of the main unit (receiver). To display the minimum, maximum or the current reading press MEM button.
If no button is pressed for the next 15 seconds, the unit will return to the current temperature and humidity display.
To clear the memory, press and hold MEM button for two seconds and all previously stored readings will be erased.
LOST COMMUNICATION
If the main unit display line for the remote sensor reading goes blank, press and hold DOWN (▼) button for 2 seconds to begin a new signal search. If the signal still isn’t received, please make sure that:
•The remote sensor is in its proper location.
•The distance between main unit and remote sensor(s) is not over 100 feet (30 meters)
•The path between units is clear of obstacles. Shorten the distance if necessary.
•Fresh batteries are installed correctly in both remote sensor and main unit.
If there is no reception, please perform the following steps:
19
•Bring the main unit and remote sensor close together.
•Remove four (4) small screws from the back of the remote sensor with small Phillips screwdriver, and open the battery compartment.
•Remove the batteries from the battery compartment and reinstall them in the same manner. Remote sensor LED indicator will flash showing transmission of the signal.
•Remove the batteries from the main unit and reinstall them in the same manner.
•On the main unit select the same channel number using CHANNEL button as set on the remote sensor. The remote temperature and humidity appeared on the main unit’s display will show that transmission is being received successfully.
TRANSMISSION COLLISION
Signals from the other household devices such as wireless doorbells, home security systems, and entry control, may interfere with this product or cause temporary reception interruption. This is normal and will not affect the general performance of the product. The transmission and reception of the temperature and humidity readings will resume once the interference subsides.
WWVB RADIO CONTROLLED TIME
The NIST (National Institute of Standards and Technology) radio station (WWVB) is located in Ft. Collins, Colorado. It transmits an exact time signal continuously throughout the most of the continental United States at 60 KHz frequency. The Barometric Weather Forecaster can receive this WWVB signal through the internal antenna from up to 2,000 miles away. Due to the nature of the Earth’s ionosphere, reception can be limited during the daylight hours. The radio controlled clock will search for an alternate station that receives the
1920
