Installation and Setup
Activate batteries and test thermostat
homexperttm by Honeywell THR872CUK Wireless Programmable Thermostat
Choose location and install thermostat
AUTOMANOFF
Remove cover and discard plastic tab inside to activate batteries
Remove thermostat cover and battery compartment cover, then discard the plastic tab inside to activate the batteries. The first time you do this, you will be prompted to set the date, time and preferred screen language. After this, you should check to make sure the thermostat can communicate with the relay box.
1Make sure electrical power is on and thermostat is set to OFF mode (see page 11).
| Install the thermostat on a wall or table about 1.2 to |
| 1.5 metres above the floor. To check a location, set the |
| thermostat to Test mode (see page 24), then check to verify |
| that the green light on the relay box is still flashing. If it does |
| not flash, find another location closer to the relay box |
Wall mounting | • Do not install near sources of hot or cold air (radiators, |
windows, heating or cooling ducts). |
Press OFF, then press and hold these buttons to test
TEST TRANSMIT
Green light on relay box should begin flashing
2Hold the thermostat
3If the system is working properly, a green light on the relay box should begin flashing. If nothing happens, or if the red light begins flashing, see “In Case of Difficulty” on page 32.
To exit Test mode at any time, press any MODE button (Auto, Manual or Off; see page 11).
NOTE: This symbol will flash on the screen when battery power is low. Remove cover as shown at left and replace batteries with two fresh AA alkaline batteries.
• Install at least 30 cm from metal objects. |
• Install at least 1 metre away from other electronic devices |
(TV, sound system, PC, etc.). |
Table stand |
assembly |
24 | 25 |