Indicator | Temperature | Humidity | Shows | |
displayed | Current | |||
Range | Range | |||
on the unit | Environment | |||
|
| |||
|
|
|
| |
| 20˚C to 25˚C | 40%RH- | Ideal range for | |
COM | both relative | |||
| (68˚F to 77˚F) | 70%RH | humidity and | |
|
|
| temperature | |
|
|
|
| |
WET | OVER | Contains excess | ||
(23˚F - 122˚F) | 70%RH | moisture | ||
| ||||
|
|
|
| |
DRY | Below | Contains | ||
inadequate | ||||
(23˚F - 122˚F) | 40%RH | |||
| moisture | |||
|
|
| ||
|
|
|
| |
No | Less than | 40%RH |
| |
20˚C (68˚F) or |
| |||
to | No comment | |||
Indicator | More than | |||
70%RH |
| |||
| 25˚C (77˚F) |
| ||
|
|
|
WEATHER FORECAST
The weather station is capable of detecting atmospheric pressure changes. Based on collected data, it forecasts the weather for the next 12 to 24 hours.
When the |
|
|
|
| |
display |
|
|
|
| |
shows... |
|
|
|
| |
Forecast is... Sunny | Partly | Cloudy | Rainy | Snowy | |
Cloudy | |||||
|
|
|
|
NOTE:
1.The weather forecast accuracy is approximately 70%.
2.Display shows forecasted, not current conditions.
3.The “Sunny” icon indicates clear weather, even when displayed during
11
TEMPERATURE AND HUMIDITY SCANNING Press and hold CHANNEL button for 2 seconds
–the indoor, channel 1, channel 2 and 3 readings will be displayed in sequence automatically.
LOST COMMUNICATIONS
If the main unit display for the remote sensor goes blank, press and hold [ ] button for 2 seconds to begin a new signal search. If the signal still isn’t received, please make sure that:
1.The remote sensor is in its proper location.
2.The distance between main and remote units is not over 100 feet.
3.The path between the units is clear of obstacles. Shorten the distance between units if necessary.
4.Fresh batteries are installed correctly in both remote and main units.
Note: When the temperature falls below freezing, the batteries in outdoor remote sensors may have reduced voltage supply and a shorter effective range. We recommend to
Use lithium-ion batteries at the temperatures below 32°F
If everything listed above is in order and there is no reception anyway, please perform the following steps:
1.Bring main unit and remote sensor close together.
2.Remove 4 small screws from the back of the remote sensor and open the battery compartment.
3.Remove the batteries from the battery compartment and reinstall them in the same manner. Remote sensor
LED indicator will flash showing transmission of the signal.
4.Remove the batteries from the main unit and reinstall them in the same manner.
5.On the main unit select the same channel number as set on the remote sensor. Outdoor temperature
on the display will show that transmission is being received successfully .
12
