TRANSMISSION COLLISION
Signals from other household devices, such as doorbells, home security systems, and entry controls, may interfere with this product and may cause temporary reception failure. This is normal and will not affect the general performance of the product. The transmission and reception of temperature readings will resume once the interference subsides.
ATOMIC CLOCK
1.After the main unit receives readings from the remote sensor(s), the atomic time signal receiver will automatically search for the time signal. This takes about
2.When the radio signal is received, the date and time will be set automatically, and the [ ] icon will appear.
3.If in 8 minutes the time signal has not been received, press “MODE” button to set the time manually. Always place the main unit by the window for better reception.
4.The clock will continue to search for the WWVB time signal daily for every hour between 1:00 am and 4:30 am. After the signal has been successfully obtained, the time and date will be updated automatically.
CALENDAR AND CLOCK DISPLAY MODES
Date is displayed in
13
SETTING CLOCK MANUALLY
TIME ZONE
1). Press MODE to select HOUR/MINUTE/WEEKDAY display.
2). Press and hold “UP” button for 3 seconds to enter into TIME ZONE display mode.
3). Keep holding “UP” button to select the desired
TIME ZONE.
CLOCK
1). Press and hold MODE for 3 seconds: the year will flash.
2). Press “ ” or “ ” to change the flashing digits. After the first value is set, press MODE again. Continue setting month, day, 12/24 hour time display, minutes, day of week, and Fahrenheit or Celsius display.
When you’ve set the last value, press MODE for the last time to return to regular mode.
ALARM
To set any alarm,
1. Press [ALARM ON/OFF] once to display alarm time. If the alarm is off,
“OFF” will be displayed.
2. Press and hold [ALARM ON/OFF] for two seconds. The hour digit will flash.
3.Enter the hour using [ ] or [ ].
4.Press [ALARM ON/OFF] again. The minute digits will flash.
5.Enter the minutes using [ ] or [ ].
6.Press [ALARM ON/OFF] again to exit.
7.Repeat the same procedure to set a Single and
14