W8600F Air Cleaner Monitor
INSTALLATION INSTRUCTIONS
APPLICATION
The W8600F Air Cleaner Monitor is an option available for use with the F50F and F52F Honeywell Electronic Air Cleaners (EAC). The series two F50F and F52F require a solid state power supply that is compatible with the W8600F driver board. Any series one F50E, F or F52F can be upgraded to use the W8600F when the power supply is replaced and the driver board (included in W8600F kit) is installed.
The W8600F function indicator panel has four liquid crystal display (LCD) arrowheads that point to ON, BATTERY, SERVICE or FAULT. See Fig. 1. The arrowheads darken to indicate the existing EAC condition. See Table 1.
LCD
ON
BATTERY
SERVICE |
|
FAULT |
|
Air Cleaner Monitor | FUNCTION |
INDICATOR | |
| PANEL |
INSTALLATION
When Installing this Product..
1.Read these instructions carefully. Failure to follow the instructions could damage the product or cause a hazardous condition.
2.Check the ratings given in the instructions and on the product to make sure the product is suitable for your application
3.Installer must be a trained, experienced service technician.
4.After completing the installation, use these instruc- tions to check out the product operation.
Location
The styling of the W8600F is designed to blend with the latest T8600 family of Honeywell Chronotherm¨ IV Deluxe Programmable Thermostats. A special mounting template is included for mounting next to the T8600. The W8600F can also be mounted at any other convenient location in the living area or equipment room. See Fig. 2.
NOTE: The W8600F shares no common electrical con- nections with the thermostat.
RESET BUTTON
M11965
Fig. 1. W8600F Air Cleaner Monitor features.
Table 1. Description of W8600F Function Indicator
Panel.
|
|
Indicators | Condition |
|
|
ON | EAC is powered and system blower is |
| running. |
|
|
BATTERY | Battery that maintains W8600F |
| memory is low and needs to be |
| replaced. |
|
|
SERVICE | EAC prefilter and cells need to be |
| washeda. |
FAULT | •Shorting of collector plates. |
| •Continuous ionizer or collector plate |
| arcing. |
| •Power supply failure. |
| •Excessive current. |
| •Major reduction in high voltage. |
| •EAC prefilter and cells are past |
| SERVICE level of dirt and need to be |
| washed immediately. |
| Call a service technician. |
|
|
aThe reset button is located on the bottom of W8600F. After the prefilters and cells are cleaned and reinstalled, press this button to turn off the SERVICE indicator and reset the wash frequency timer.
® U.S. Registered Trademark
Copyright © 2002 Honeywell International Inc. • | • All Rights Reserved |
|