W8600F AIR CLEANER MONITOR
Select Wash Frequency
Use the W8600F DIP switches to program the time between SERVICE indications. Be sure to select the setting according to the conditions of the home. Factors to consider include the duty cycle of the EAC, the number of people and pets, and activities such as woodworking and other crafts that are being done in the home.
Refer to Table 2 to select the wash frequency. Set the W8600F DIP switches to match the selection. See Fig. 4. The time listed represents actual run time of the EAC, not calendar days.
Table 2. Wash Frequency Options.
|
|
|
|
DIP Switch Settings | Wash Frequency | ||
|
|
|
|
1 | 2 | 3 | Days (Run Time) |
|
|
|
|
Off | Off | Off | 10 |
|
|
|
|
On | Off | Off | 20 |
|
|
|
|
Off | On | Off | 30 |
|
|
|
|
On | On | Off | 40 |
|
|
|
|
Off | Off | On | 50 |
|
|
|
|
On | Off | On | 70 |
|
|
|
|
Off | On | On | 100 |
|
|
|
|
On | On | On | 180 |
|
|
|
|
BACK OF W8600F
BATTERY
IN HOLDER
DIP SWITCHES
3.Check that the battery is correctly installed in the W8600F battery holder.
4.Snap the W8600F onto the base.
5.Turn off the power for the EAC.
WARNING
Electric Shock Hazard.
Can cause electrical shock or equipment damage.
Disconnect EAC power and open the access door before opening power supply box cover.
6.Open the power supply box cover.
7.Remove the plug from the side of the power supply box (plug can be a metal knockout or a blank termi- nal strip).
8.Install the terminal block/cable assembly supplied with W8600F kit.
9.Plug the connector on the end of the cable assem- bly into the J2 terminal on the driver board (included with W8600F kit). See Fig. 5.
POWER SUPPLY
BOX COVER 
AIR
SYSTEM
DRIVER
J2 BOARD
TERMINAL
STRIPJ1
MOUNTING
SCREW
POWER
SUPPLY
UP
1 2 3
1 |
3 | 4 |
WIRING TERMINALS (3)
RESET BUTTON
POWER SUPPLY BOX
M11970
Fig. 5. Installing the driver board on the EAC.
10.Plug the driver board assembly into the J1 power supply connector.
M11969A
Fig. 4. Back of W8600F.
Wiring
1.Run a 3
18 gauge) from the W8600F to the terminal strip on the air cleaner.
IMPORTANT
Connect cable to W8600F before attaching to the air cleaner terminals to minimize the risk of damage due to static electricity.
2.Connect the wires to terminals E1, E3 and E4 on the W8600F. See Fig. 4.
NOTE: This W8600F kit is configured to operate with a power supply that is controlled by an airflow switch (AFS). If your application does not have an AFS, place the black shorting bar (found in the bag assembly) on power supply connector J3, pins 1 and 2, as shown in Fig. 6.
SHORTING BAR
J3 | 4 | 3 | 2 | 1 |
M20890
Fig. 6. Placing shorting bar on power supply for
applications without AFS.
11.Replace the power supply box cover.
3 |
