* Certain Models Only
** May vary according to model
The following is a list of commonly encountered problems and solutions.
If any of these problems persist contact your local Hoover representative.
t
Check that the dust container lter and motor are clean.t
t
Cleaning power is weak
Empty dust container.t
Check and clean th lter and motor.t
Check and clean the Floor Brushest
Check and clean the sensors.t
Check and clean the drive wheels.t
The Remote Control** does not workCheck the batteries.t
t
t
charge
t
the Charger Base.
cleaning
Clean the dust container an lter.t
Check the brushes and drive wheels for dirt and debris.t
cleans intermittantly
Check the cleaning times set.t
Check and clean the sensors.t
t
there is no error code display
Contact your local Hoover representativet

Error Codes

The following codes may appear during use or on start up.

Failure Code Explanation

Er01 See ‘Cleaning the Edge Cleaning Brushh
Er02 Debris trapped in the Floor Brushes. See ‘Cleaning the Floor Brushes’
Er04 Left Drive Wheel motor overloaded. See ‘Cleaning the Drive Wheels’
Er05 Right Drive Wheel motor overloaded. See ‘Cleaning the Drive Wheels’
Er06 Both Drive Wheel motors overloaded. See ‘Cleaning the Drive Wheels’
Er07 Left or Right Drive Wheel not making contact with the ground. See ‘Cleaning the
Drive Wheels’

Er08

Er09

Er10

Er12

Dust container is absent. Replace Dust Container.
Check the battery connection.
ATTENTION: If any of these failures persist. Contact your local Hoover representative. DO NOT try to
GB
TROUBLESHOOTING
RoboCom2Manual2011__GB.indd 14 14/07/2011 13.40.17
Debris in the Right Edge Cleaning Brush.
See ‘Cleaning the Edge Cleaning Brushh
Debris in the Left Edge Cleaning Brush.