5
5
Chapter 1: Preparaon for UseChapter 1.1 : What Kind of Water May be Used?Chapter 1.2 : Filling the Water TankChapter 1.3 : Seng the Temperature
Due to the powerful output of steam, Hoover recommends the use of an acve
ironing board with blowing and vacuuming funcon which allows escape of any
excess steam.
Place the ironing system on a stable and level surface, for example on the hard part of
an ironing board or on a heat-resistant surface.
The Hoover ironing system has been designed to be used with tap water only.
There is no need to use dislled or pure dislled water.
Nevertheless, in case you live in a hard water area, you can mix 50% of dislled water
with 50% of tap water.
Do not use any other kind of water or do not add any contents to water tank as it can
damage your appliance.
Filling With Water
Remove the mains plug from the wall socket before lling the iron.
Please ll your iron with normal tap water before using for the rst me.
Set the steam buon to the “0” posion and open the water ll cover.
Use the water beaker aached to ll clean tap water into water tank unl “MAX”
lling level.
Push the water ll cover rmly to close and dry any spilt water around the
enclosure of the appliance, do not overll.
Warning: Do not add vinegar, hot water, perfume, or any other kind of chemical
agents or any other contents in the water tank. It could damage the steam
generator and shorten its life use.
Stand the iron on its heel and plug the power cord into wall socket and the LCD
backlight will come on, indicang that the iron is receiving power.
Press on the iron set buon unl you get the desired temperature seng. We
recommend using the LCD panel display fabric as a guide.
When the LCD panel shows the text (fabric name) ashing and LCD panel of
the top of the temperature mark recycling by short to long, indicang that the
soleplate is heang up.
They will stop ashing when the iron reaches the selected temperature.
When the LCD panel shows the text (fabric name) ashing and LCD panel of
the top of the temperature mark recycling by long to short, indicang that the
soleplate is cooling down.
When iron in working status, push the set buon and hold on for more than 3
seconds, then the iron will be in stand by status directly.
Stand by
Temperature
Mark
Fabric