Step 1 Assemble handle
2 | A |
| A |
D |
| C | B |
|
|
Place upper (B) and lower (C) handle sections on a flat surface with cord hooks (A) on top. With hands on sides of handle sections, push handle sections together firmly until they “click” into place.
Do not press against the rod (D) extending from the lower handle. If the rod breaks or bends, the cleaner will not work properly. Do not push handle together with your hands on the ends of the sections.
Step 2 Attach cord
3 | “UP” | G |
|
|
|
|
|
|
|
| |
D |
| C | F | E | B |
4 |
G |
Note: The small red tab (E) above the ON/OFF switch (F) is for shipping purposes only and may fall off during assembly. If it does not fall off, the tab will be removed during the final steps of assembly.
Turn handle over. Insert large rectangular end of cord into pocket in bottom of handle, with side marked “UP” visible.
Make sure rectangular end is pushed into handle as far as possible.
Slide cord protector (G) toward upper handle (B).
Rotate cord protector (G) as shown (toward back of handle).
5 |
|
| G |
H | I |
|
With (G) pointing downward, press groove (H) into slot (I).
Pull cord tight.
6 |
UP |
G |
Press cord into place at each of the three notches indi- cated and note correct positioning of (G).
Do not plug cleaner in until assembly is totally complete.
Continued ➜ | 3 |
